Hi,

I'm trying to set up a label-printing report using the wizard. I am using a non-standard size sheet of labels on an A4 sheet where each label is 104mm by 58mm (ten per sheet), and have inputted all the measurements into the custom size screen, but when I come to preview the labels, there are only eight on the sheet as opposed to ten.

How can I correct this?

can you do this in word ???
if so do a mail merge straight out of Access in to word

check margins on your page set up headers and footers etc

g

preview the report
design mode and shrink the header/footer (or remove it)
then check this

Thanks Gary, works fine now.

sh*t -- got one right -- blimey and i think I can understand my own blurreb