Continuous (tractor feed) dot matrix labels

[melissa_may1]

Hi All,

I'm having a very difficult time with getting labels to work on Access 2007.

I'm using continuous tractor-feed labels on a dot-matrix printer. the labels are 3.5" wide and 1" high.

The first problem is that the Page Setup will not allow me to set a Top Margin other than 0.622 inches. No matter what I do (so far!) each time I change the Top Margin, it goes back to 0.622.

The Bottom Margin does a similar thing, but stays at .005 inches, and the Left Margin insists on staying at 0.25 inches.

Only the Right Margin will allow me to set a number other than 0.00.

I've tried Page Setup, adding a custom paper size (Labels - 3.5" x 1"), changing the printer setup, etc.

Nothing seems to work.

Any ideas?

By the way, I'm on Access 2007 (12.0.6535.5005) SP2.

Thanks!

 

[melissa_may1]

Bueller...Bueller....Bueller....

 

[Ziggy1]

did you check off to use "specific Printer" in the report design?

You didn't say what is happening