Enable Content - no message

[Gkirkup]

I am updating a system to 2010 format and .accdb. When I copy the program I get an 'Enable Content' message, and some of the menus are not displayed. That is OK, I click on the Enable Content message and all is fine.
But today I have the same partial display as when I have the 'Enable Content' message, but no 'Enable Content' error message! How do I remove that situation and get back to normal?

Robert

 

[boblarson]

Check under FILE > ACCESS OPTIONS > TRUST CENTER > MESSAGE BAR and make sure that it doesn't have it set to not display (disable content and do not display). So, why not just set a trusted location and not worry about it anymore?