Center text top <--> to bottom on command buttons?

[WinDancer]

Is there a simple way to set text on command buttons so that it stays centered even at different screen resolutions?

I am using Access 2003.

Also using the form resizer.

Thanks!

 

[KenHigg]

I've never seen them anything but centered - ?!

 

[WinDancer]

I design in the lowest resolution settings.

In design view you can change the height/width of the buttons, and the text size.

So I make the command buttons a little larger, then use slightly larger text, leaving a margin...

I set the Left, Right, Top margins to .02, which leaves a little space from the edge of the buttons.

When a customer runs at higher resolution the text is now not evenly centered top to bottom.

Several customers run different resolutions, so this happens with every application.

Not a crisis, and everything still works- but I hate it when you spend a huge amount of time on a system and then the butons look unprofessional.

Any ideas?

Thanks

 

[KenHigg]

I design in the lowest resolution settings.

In design view you can change the height/width of the buttons, and the text size.

So I make the command buttons a little larger, then use slightly larger text, leaving a margin...

I set the Left, Right, Top margins to .02, which leaves a little space from the edge of the buttons.

When a customer runs at higher resolution the text is now not evenly centered top to bottom.

Several customers run different resolutions, so this happens with every application.

Not a crisis, and everything still works- but I hate it when you spend a huge amount of time on a system and then the butons look unprofessional.

Any ideas?

Thanks

I hate to be a pester but can you post an image of the suspect but with its mis-aligned text?

 

[WinDancer]

Here you go.....

 

[KenHigg]

Please tell me you did a shrink on that image before you posted it - ?!