I have a report with two subreports. The first one is ok, but the second subreport's source object changes to that of the first subreport when I save the main report. I change it and it changes back. My report is rejecting this source object like an organ of the wrong blood type. I must be doing something very stupid, but I can't see where.
evasive subreport
- Thread starter CarlyS
- Start date
They do... Wais and Wisc
I have checked their names as controls on the form and as stand alone reports and they are different both times. Is there any other place a report name is stored where they might be the same?
I have checked their names as controls on the form and as stand alone reports and they are different both times. Is there any other place a report name is stored where they might be the same?
Also, now I am occasionally getting the following error message when I try to view the report:
The instruction at "0x77fcc37c" referenced memory at "0xfffffff8." The memory could not be "read." Click Ok to terminate the program.
I click Ok and then this comes up:
The instruction at "0x77fcc832" referenced memory at "0xfffffff8." The memory could not be "read." Click Ok to terminate the program.
I click Ok again and then Access closes.
Maybe this can give someone a clue about what I've done wrong.
The instruction at "0x77fcc37c" referenced memory at "0xfffffff8." The memory could not be "read." Click Ok to terminate the program.
I click Ok and then this comes up:
The instruction at "0x77fcc832" referenced memory at "0xfffffff8." The memory could not be "read." Click Ok to terminate the program.
I click Ok again and then Access closes.
Maybe this can give someone a clue about what I've done wrong.
