Headers and Detail Secton

[Freelak]

I am having a problem with page headers.

I have a report where the detail is over a full page. When I print the report, the first page is only the page header, the second shows the page header again and then the detail (which is what I want on the first page). The third page shows the Page header again with the rest of the detail (again, what I want on the second page). How do I get the first page to print the header with the detail. The rest of the report is printing correctly.

Thank You!

 

[capri]

Do you have a page break in your report in error?

If you go to design view of the Northwinds Catalog report, just below the commitment to quality box, you will see 7 small dots at the left of the page, this seems to be Access's page break.

 

[Freelak]

I tabbed through every item in the report. I found no "HeaderPageBreak". Just the Text, Fields and Picture I added. If I remove the Header or if I make the Page Header not visible, it starts the detail on the first page (but no header of coarse).

Thank you for your input

 

[DJBummy]

I think this may be your problem.
Check the properties for the Details Section and make sure the Force New Page is set to None.

D.J.

 

[Freelak]

D.J.

That perameter was set to "none".

I have cleared up the problem however. I had turned Report Header/Footer off, thinking this would completely remove these items. I turned them back on and set visible to "no" and height to "0". Now everything prints the way it should.

Thank you for your help!