Blank page sneaking in

[Peter Paul]

I have a report which should be two pages. The page break is identified by a page break command. However, rather than the report then displaying the second page, it displays a blank page, (it does have the header and footer on the "blank page", but nothing further.)

I have looked for all the obvious, but have not been able to fix this really irritating problem.

Thanks for any help,

Peter Paul

 

[tracey75]

You could also try:
Make sure in Design View that your page does not exceed 6 1/2 inches otherwise it will put in a blank page inbetween the normal pages

 

[marnieg]

I was having the same problem and it WAS the width of the report. It must fall within the 6 1/2 width range.

Thanks

 

[boblarson]

I was having the same problem and it WAS the width of the report. It must fall within the 6 1/2 width range.

Thanks

Only if your margins are 1 inch. If they are less, then the width can be greater.