blank page between report pages

Pharcyde

Arriba Arriba!!!
Local time
Today, 20:07
Joined
Sep 4, 2003
Messages
116
I have a 2 page report - but its now 3 because a blank page comes in between the pages. I thought it was a margin problem - like you get in word, so have played around with them but still get the blank one.

Its now getting very frustrating - even though its only a cosmetic thing.

Can anyone please help!?
 
Check the properties for your report sections make sure that "Force new page" is set to None (or the appropriat setting you desire)

This most likely is the source of your headage....

Regards

The Mailman
 
Ahhh ...

I looked this up today ... go to your help menu in access and type in report blank page ... It said that the margins are not set correctly for how wide the data actually is on the page. So go into design view on your report and then do file, page setup, then change your margins and or change it to landscape instead of portrait view.

Or you could just make the information in your form not as wide ... and make sure to change your far right side of your report as well.

:) It worked great on mine. All fixed up now. :)
 
This is a common problem, your pages are either wider (usually) or longer than you think.

In the Page Setup menu, set the right margin to .25" and that will kill any small width error. Sometime also setting the right margin to .25" will show your mistake.
 

Users who are viewing this thread

Back
Top Bottom