Situation: Paper width to adjust on to a drum that have grooves.
Goal: end goal is to place both edges onto "peaks" NOT 'Valleys or groove". Both edges must be atleast 0.1" away from "valley or call it grooves"
Example:
User Entry: 1.75"
If the width of the paper (user input) is less than 7.5" inch then add fields from table:
tblOp: id, OpPeak, OpValley~1, .547,.153
Otherwise add fields from table:
tblDr: id, DrPeak, DrValley ~1, 735,.156
Loop thru recordset and add fields until they are more than equal to 1.75"
If the last value is from field "OpValley" then check the value and move the paper onto "OpPeak" and at least 0.1" off "OpValley"
If the last value is "OpPeak" then check the value and make sure "edge of the paper" is 0.1" off "OpValley"
Do until the same thing for the other edge of the paper and make sure both edges are on "OpPeak" and 0.1" off "OpValley"
***End goal is to make sure both edges of the paper are 0.1" off "OpValley"***
Example of how drum looks like with peaks and valleys with Drive side (Dr) vs Operator side (Op)
Goal: end goal is to place both edges onto "peaks" NOT 'Valleys or groove". Both edges must be atleast 0.1" away from "valley or call it grooves"
Example:
User Entry: 1.75"
If the width of the paper (user input) is less than 7.5" inch then add fields from table:
tblOp: id, OpPeak, OpValley~1, .547,.153
Otherwise add fields from table:
tblDr: id, DrPeak, DrValley ~1, 735,.156
Loop thru recordset and add fields until they are more than equal to 1.75"
If the last value is from field "OpValley" then check the value and move the paper onto "OpPeak" and at least 0.1" off "OpValley"
If the last value is "OpPeak" then check the value and make sure "edge of the paper" is 0.1" off "OpValley"
Do until the same thing for the other edge of the paper and make sure both edges are on "OpPeak" and 0.1" off "OpValley"
***End goal is to make sure both edges of the paper are 0.1" off "OpValley"***
Example of how drum looks like with peaks and valleys with Drive side (Dr) vs Operator side (Op)