Report Size

[jbphoenix]

I can't seem to change the size (width) of my report. I'm in design mode and I can't change the width. Right now the width is bigger than I need. I try to change the width in the report properties but it goes right back to what it is now. I click on the edge of the report and try to move the edge to where I would like and it goes right back to the way it was.

 

[pbaldy]

That typically means that some control is out at the edge. Make sure there aren't any lines tucked up near the edge of any section. Those are what usually screw me up.

 

[jbphoenix]

thanks Paul you were right there was a line all the way at the bottom of the page that I didn't notice.