struggling to create Avery 8160 Label

[ahvc]

Dear Access friends,
I am trying to create a label report for a friend who is using Avery 8160 label sheets.

I used the choice of 'Label wizard' under New Reports. I chose the table, then I chose Avery J8160, 38.10 mm x 63.50 mm 3 down; Metric Measure, Sheet feed. But it produces 3x7, while the sheets are 3x10. This obviously messes up on the label sheet.

Can you please help me how to configure a 3x10 8160 label report. I am using Access 2000.

I also tried customizing a label report, but in vain. I searched the net if I can get the exact measurement and dimensions of the 8160 label sheet so I can try to duplicate it, and have not been able to do so far.

please help.

Advance thanks!

AHVC.

 

[neileg]

But the Avery type 8160 is 3x7.

If you have 10 labels down at 38.10mm this is 381mm,but an A4 page is only 297mm.

Whatever these labels are, they cannot be 3x10 at 38.10mm deep, and therefore cannot be Avery 8160.

 

[ahvc]

Which is avery 3x10?

Thanks for that Neil,

Would you know which Avery type should I use to get 3x10.

Also what may be a source where I try to get the dimensions of a 3x10 Avery if I want to customize it?

Thank you so much
AHVC

 

[neileg]

You could try a look at www.avery.com

This might help