Dot Matrix printer

[tripico]

I just loaded the ML 590 driver to see what was in there. Are you printing directly to the printer or going through the spooler?

What kind of printer do you have?
Where did you insert the page break in the report?

 

[tripico]

I just loaded the ML 590 driver to see what was in there. Are you printing directly to the printer or going through the spooler?

The printer is hooked up directly to my notebook.

 

[RuralGuy]

The printer is hooked up directly to my notebook.

The driver supports spooling a print job or printing directly to the printer. Which do you have selected? It is on the Advanced tab. There are other settings on the Device Settings tab that you should review as well.

 

[RuralGuy]

What kind of printer do you have?
Where did you insert the page break in the report?

As I said earlier, I made no special considerations for the report. I did not insert any page breaks in any of my reports.

 

[tripico]

The driver supports spooling a print job or printing directly to the printer. Which do you have selected? It is on the Advanced tab. There are other settings on the Device Settings tab that you should review as well.

I have it selected as spool print. What do you have under print processor?
I have "winprint" ~> "RAW"

Under Printing Defaults I have the paer source as "Automatic"

I'll try some other settings tomorrow as I do not have the printer with me now.

Thanks for all your help.. I'll try tomorrow and report back!

 

[RuralGuy]

Unfortunately I am not where the printer is located so I can't check. I would play with some of those settings to see if you can make anything change. What kind of paper do you have selected for the tractor feed? You are using the tractor feed right?