File not found

[Tony McGuire]

Hi
I have created a number of buttons on a form which relate to an On click 'event procedure' (Docmd.OpenForm "frm****", AcNormal. Up until now this has worked perfectly. Now whenI add new buttons or click an existing button I get the following message: "File not found" ! Why is this and can anydody help me?
Danmac

 

[DCrake]

File Not Found is not the normal error messge you get if it is looking for a form. What is the actual error being reported and on what line is it being raised?

 

[Tony McGuire]

Hi David,

Sorry I can't see what form it is looking for. The message, as I said, only appears when I press one of my buttons. There is no ' Error number' just the message 'File not found'. Personally I have the feelig that the fault lies somewhere in the related query or server. What do you think?
Danmac

 

[DCrake]

What is behind the on click event of the button? What is it supposed to do?

 

[Tony McGuire]

Hi again,
The button when pressed should trigger off an event which in turn should open a form but at the momet it doesn't. I just get the error message. The form it should open is based on a query.
Danmac

 

[DCrake]

If you try and open the form normally do it load ok without errors?

 

[Tony McGuire]

Hi,
yes but with reservations! On the form, when I open it normally, I have a 'button' with an event (Docmd.Close) this should close the form but instead I get the same error message (no need to tell you what that says). I have to close it by right clicking on its tab and selecting close.
By the way I am using Access 2010
Danmac

 

[Tony McGuire]

Hi,
I found that the best solution was to remove and re-install Access 2010 now all my problems are solved and I now consider this matter as solved.
Danmac